Removal and replacement: Hard-disk drive (HDD)
NOTE: M586 all; 556xh printers only.
●
Introduction
●
Step 1: Remove the formatter cover
●
Step 2: Remove the hard-disk drive (HDD)
●
Step 3: Unpack the replacement assembly
●
Step 5: Install the HDD
●
Step 6: Install the formatter cover
●
Step 7: Reinstall the product rmware
Introduction
This document provides the procedures to remove and replace the hard-disk drive (HDD).
Before performing service
Turn the printer power o
◦
Disconnect the power cable.
WARNING! To avoid damage to the printer, turn the printer o, wait 30 seconds, and then remove the
power cable before attempting to service the printer.
CAUTION: This part contains components that are electrostatic discharge (ESD) sensitive. To reduce
the possibility of ESD damage, always touch the sheet-metal chassis to ground yourself before touching an
ESD sensitive part.
Use the table below to identify the correct part number for your printer. To order the part, go to
www.hp.com/buy/parts.
Hard-disk drive (HDD) kit part numbers
G1W41-67902 320 GB hard-disk drive (HDD) (586 all; 556xh) with instruction guide
Required tools
No special tools are required to install this part.
After performing service
Turn the printer power on
◦
Connect the power cable.
◦
Use the power switch to turn the power on.
60 Chapter 1 Removal and replacement ENWW