Print mechanism kit (586)
●
Introduction
●
Acclimation
●
Installation notes
●
Removal and replacement strategy
●
Step 1: Unpack the Replacement Print Mechanism (PM)
●
Step 2: Remove the right cover (outer) (PM)
●
Step 3: Remove the formatter cover (PM)
●
Step 4: Remove the rear cover (PM)
●
Step 5: Turn the power o defective unit (DU)
●
Step 6: Remove the formatter cover (DU)
●
Step 7: Remove the right cover (outer) (DU)
●
Step 8: Remove the rear cover (DU)
●
Step 9: Remove the formatter and formatter cage (DU)
●
Step 10: Remove the power supply (DU)
●
Step 11: Remove the power supply mounting bracket (DU)
●
Step 12: Remove the blank cover (DU)
●
Step 13: Remove the Integrated Scanner Assembly (ISA) (DU)
●
Step 14: Install the Integrated Scanner Assembly (ISA) (PM)
●
Step 15: Install the blank cover (PM)
●
Step 16: Install the power supply mounting bracket (PM)
●
Step 17: Install the power supply (PM)
●
Step 18: Install the formatter and formatter cage (PM)
●
Step 19: Install the rear cover (PM)
●
Step 20: Install the right cover (outer) (PM)
●
Step 21: Install the formatter cover (PM)
●
Step 22: Turn the power on print mechanism (PM)
●
Step 23: Prepare the Defective Unit (DU) for Shipping
Introduction
This document provides the procedures to install the print mechanism (PM) kit.
514 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...