2. Unpack the replacement part from the packaging.
CAUTION: If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on
the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using
disposable gloves when handling rollers or pads or washing your hands or before touching rollers or
pads.
IMPORTANT: Make sure that all of the shipping materials (for example shipping tape) are removed
from the replacement part prior to installation.
Step 3: Install the retention clips
1. If a spring comes o of a retention clip, make sure that it is correctly repositioned on the clip.
Figure 1-14 Check the clip spring
ENWW Removal and replacement procedures 23
To Next Page
Loading...