Install accessory: Small outline dual in-line memory module (SODIMM)
●
Introduction
●
Step 1: Remove the formatter cover
●
Step 2: Remove the small outline dual in-line memory module (SODIMM)
●
Step 3: Unpack the replacement assembly
●
Step 4: Install the SODIMM
●
Step 5: Install the formatter cover
Introduction
This document provides the procedures to remove and replace the small outline dual in-line memory modulel
(SODIMM).
Before performing service
Turn the printer power o
◦
Disconnect the power cable.
WARNING! To avoid damage to the printer, turn the printer o, wait 30 seconds, and then remove the
power cable before attempting to service the printer.
CAUTION: This part contains components that are electrostatic discharge (ESD) sensitive. To reduce
the possibility of ESD damage, always touch the sheet-metal chassis to ground yourself before touching an
ESD sensitive part.
Use the table below to identify the correct part number for your printer. To order the part, go to
www.hp.com/buy/parts.
Small outline dual in-line memory module (SODIMM) kit part number
E5K48A (accessory)
E5K48-67902 (service kit)
Small outline dual in-line memory module (SODIMM) with instruction guide
Required tools
No special tools are required to install this part.
After performing service
Turn the printer power on
◦
Connect the power cable.
◦
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
ENWW Removal and replacement procedures 597
To Next Page
Loading...