After performing service
Turn the printer power on
◦
Connect the power cable.
◦
Use the power switch to turn the power on.
Post service test
Make sure that the printer initializes to a Ready state.
Print a page from the each tray to make sure that it is correctly functioning.
Step 1: Remove the tray
1. Pull the tray out until it stops.
Figure 1-557 Open the tray
Offic
ejet
En
ter
pri
s
e C
ol
o
r X5
5
6
344 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...