Before performing service
Turn the printer power o
◦
Disconnect the power cable.
WARNING! To avoid damage to the printer, turn the printer o, wait 30 seconds, and then remove the
power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to
www.hp.com/buy/parts.
Front cover part number
G1W39-67918 Front cover
Required tools
●
Small at-blade screwdriver.
●
#10 Torx driver with a 152 mm (6 in) shaft and magnetized tip.
After performing service
Turn the printer power on
◦
Connect the power cable.
◦
Use the power switch to turn the power on.
Post service test
No post service test are available for this assembly.
Step 1: Removal the control panel (556)
NOTE: This step is for the 556 printer. For the 586 printer, skip this step and go to Step 2: Remove the
integrated scanner assembly (ISA) (586) on page 208.
1. Tilt the control panel to the fully raised position.
ENWW Removal and replacement procedures 205
To Next Page
Loading...