2. Unpack the replacement part from the packaging.
CAUTION: If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on
the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using
disposable gloves when handling rollers or pads or washing your hands or before touching rollers or
pads.
IMPORTANT: Make sure that all of the shipping materials (for example shipping tape) are removed
from the replacement part prior to installation.
Step 4: Install the SODIMM
CAUTION:
ESD-sensitive part.
1. Insert the connector end of the SODIMM into the holder. Make sure that the SODIMM is fully pushed into
the connector.
NOTE: The SODIMM is keyed and can only be inserted into the holder one way.
Figure 1-991 Install the SODIMM
ENWW Removal and replacement procedures 601
To Next Page
Loading...