3 - 3
IPN 074-397-P1G
HAPSITE Smart Operating Manual
Figure 3-3 Choosing a Method
Once a method is selected, the HAPSITE will automatically check the pressures in
the gas canisters, and begin to heat up the system. When the heating sequence is
completed the software will check the tune of the instrument and automatically
make any necessary adjustments. See Figure 3-4. If autotune fails, refer to Section
7.4, Autotune Failure, on page 7-7.
NOTE: The HAPSITE takes about twenty minutes to complete the warm-up and
short autotune. Once completed, the HAPSITE is ready to run samples.
To Next Page
Loading...
