EasyManua.ls Logo

Keysight M9421A - Page 1838

Keysight M9421A
2667 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 WLAN Mode
3.12 IQ Waveform Measurement
Option # Description
In instruments without EP0, this setting is accepted but no action is
taken
"Best Spurs"
on page 1839
5
In instruments with EP0, emphasizes spur avoidance over close-in
phase noise performance
In instruments without EP0, this setting is accepted but no action
taken
Auto - Automatically selects LO (local oscillator) phase noise behavior to
optimize dynamic range and speed for various instrument operating
conditions
*Dependent on Option EP0 installation. See "Best Close-in" on page 1838 below.
The actual behavior varies somewhat depending on model number and option; for
example, you always get Fast Tuning by choosing Option #3, but in some models,
"Fast Tuning" on page 1839 is identical in effect to "Best Close-in" on page 1838.
Best Close-in
Without option EP0
:FREQ:SYNT 1
The LO phase noise is optimized for smaller offsets from the carrier, at the expense
of phase noise farther out.
The actual frequency offset within which noise is optimized is shown with in square
brackets, as this can vary depending on the hardware set in use. For example, in
some instruments this annotation appears as [offset <20 kHz]
With option EP0
:FREQ:SYNT 4
In instruments with Option EP0, the LO is configured for the best possible close-in
phase noise (offsets up to 600 kHz from the carrier), regardless of spurious products
that occur with some center frequencies. Because this is generally less desirable for
close-in measurements than the "Balanced" on page 1838 setting, parameter 1
selects "Balanced" on page 1838 in EP0 instruments, in the interests of optimizing
code compatibility across the family. Parameter 4 selects "Best Close-in" on page
1838, which is usually not as good a choice as "Balanced" on page 1838.
Balanced
:FREQ:SYNT 1
In instruments with EP0, the LO is configured for the best possible phase noise at
offsets up to 600 kHz from the carrier whenever there are no significant spurs within
the span observed with an on-screen carrier. When there will be such a spur, the LO
WLAN Mode User's &Programmer's Reference 1838

Table of Contents