■ Attaching the tilt adjustment unit and automatic positioning unit
NOTE
• Make sure to use the supplied screws.
• When attaching the simple column stand, exercise care so as not to drop the drive unit
or unit to prevent damage.
• When the units are used in combination, the straightness accuracy of the SJ-411/412
drive unit is reduced for approx. 0.2 μm (7.874 μin).
1 Remove the mount board from the simple column stand.
Simple column stand
2 Loosen the 4 securing screws to remove the mount board from the automatic
positioning unit.
Mount board
Mounting screws (M4 x 8)
Mount board
3 Attach the automatic positioning unit to the tilt adjustment unit using the 3 automatic
positioning unit securing screws.
Securing screws
(M4 x 8)
Automatic positioning unit
Securing screws
(M4 x 8)
Automatic positioning unit
Tilt adjustment unit
Automatic positioning unit securing screws
(M4 x 8)
Automatic positioning unit securing screws
(M4 x 8)
No. 99MBB765A
19-12
To Next Page
Loading...
