Ricoh Pro 8300S - Exit Junction Gate HP Sensor Error; Sc514-00; Sc515-01; Separation Motor HP Error 1: Main Relay Motor

1.SC Codes
149
2. Reconnect the harnesses around the rear fence HP sensor.
3. Replace the harness.
4. Replace the rear fence HP sensor (SEN51).
5. Replace the registration shift motor (STM14).
6. Replace the DRB.
7. Replace the IOB.
SC514-00
Error Name
Exit Junction Gate HP Sensor Error
Pattern
B
Error Condition
Exit junction gate HP cannot be detected.
Major Cause
 Malfunction due to Exit junction gate overload; the sensor shielding plate is deformed, damaged or
not attached properly.
 Connectors of the exit junction gate HP sensor and exit junction gate motor not connected properly.
 Exit junction gate HP Sensor (SEN86) is damaged.
 Exit junction gate motor (STM27) is damaged.
 DRB, IOB malfunctioned or is defective.
Solution
1. Check if the exit junction gate is overloaded, and if the sensor shielding plate is defective.
2. Reconnect the harnesses around the exit junction gate HP sensor.
3. Replace the harness
4. Replace the exit junction gate HP sensor (SEN86).
5. Replace the exit junction gate motor (STM27).
6. Replace the DRB.
7. Replace the IOB.
SC515-01
Error Name
Separation Motor HP Error 1: Main Relay Motor