Ricoh Pro 8300S - Adjust the Leading;Trailing Edge Margins; Excessive Paper Curl

3.Paper Delivery Problems
727
[A]
Leading Edge Margin
[B]
Trailing Edge Margin
Solution:
Adjust the leading/trailing edge margins.
1. In Advanced Settings for the custom paper in use, reduce the value by 0.5 mm in Adjust Erase
Margin of Leading Edge.
2. Reduce the value by 0.5 mm in Adjust Erase Margin of Trailing Edge.
3. Print the image. Is the problem resolved?
Yes
Finished!
No
Consult the product specialist. If this results in a paper jam during duplex printing, restore
the previous setting.
 The adjusted margin cannot be applied to masked images that are solid-filled or contain ruled
lines at the leading/trailing edges.
 Reducing the leading/trailing edge margin may result in a paper jam on the fusing belt stripper
plate.
Excessive Paper Curl
To eliminate curling without using the decurl unit, lower the heat roller temperature.
Lowering the temperature may result in:
 Unsatisfactory fusing
 Reduced glossiness
 Smeared for halftone images on uncoated paper
1. In Advanced Settings for the custom paper in use, select Fusing Heat Roller Temperature Adj and
reduce the value by 5 °C.
2. Print a full-page solid-fill image. Is the problem resolved?
Yes
Finished!
No
Further reduce the value by 5 °C until the problem is resolved.