Ricoh Pro 8300S - Sc486-00; Sc488-00; Waste Toner Bottle Motor Error; Waste Toner Transport Error

1.SC Codes
82
 Harness is broken.
 IOB is defective.
Solution
1. Check if the waste toner unit is overloaded (foreign objects in the unit, bearing locked or stuck).
2. Check the connector of the waste toner collection motor and the harness of the IOB connector
(connector floating or disconnected)
3. Replace the waste toner collection motor (BLM4).
4. Replace the harness of the waste toner collection motor.
5. Replace the IOB.
SC486-00
Error Name
Waste Toner Bottle Motor Error
Pattern
D
Error Condition
Waste toner bottle motor (BLM3) does not move after start up signal is sent
Major Cause
 Harness between the waste toner bottle motor (BLM3) and IOB is disconnected.
 Harness between the waste toner bottle motor (BLM3) and IOB is defective.
 Waste toner bottle motor (BLM3) is defective.
 IOB is defective.
Solution
1. Enter the SP mode, and execute SP5-805-067 (Toner Collection Bottle Motor).
2. Check the harness between the waste toner bottle motor (BLM3) and IOB (connector is loose or
disconnected).
3. Replace the harness between the waste toner bottle motor (BLM3) and IOB.
4. Replace the waste toner bottle motor (BLM3).
5. Replace the IOB.
SC488-00
Error Name
Waste Toner Transport Error