Ricoh Pro 8300S - SC720-11 to 18

1.SC Codes
219
4. Board defective
Replace the main board of Finisher SR5110/SR5120
* Before replacing the board, check if the SC occurs in the same way.
SC720-11 to 18
Error Name
 720-11: Transport Motor 2 Error (Junction Gate Transport)
 720-12: Transport Motor 3 Error (Horizontal Transport)
 720-13: Transport Motor 4 Error (Registration)
 720-14: Transport Motor 5 Error (Shift tray 1 Transport)
 720-15: Transport Motor 6 Error (Pre-Stack)
 720-16: Exit Motor 1 Error (Shift Tray 1 Exit)
 720-17: Exit Motor 2 Error (Shift Tray 2 Exit)
 720-18: Exit Motor 3 Error (Staple Tray 1 exit)
Pattern
 720-11: D
 720-12: D
 720-13: D
 720-14: B
 720-15: B
 720-16: B
 720-17: B
 720-18: B
Error Condition
DCM drive software detects a motor drive error. (The first four times are reported as jams. An SC is
issued when it is repeated five times.)
Major Cause
 Power of the downstream device is not turned on.
 Motor is defective
 Connector is not connected properly.
 Harness is damaged
 Motor is overloaded.
 Encoder is defective.
 Board is damaged.
*Corresponding motors:
 720-11: JG transport motor <DCSM03>