Ricoh Pro 8300S - SC Code Descriptions

1.SC Codes
32
SC Code Descriptions
Here are some important points to keep in mind when working with the SC codes:
 If a problem concerns a circuit board, disconnect and reconnect the connectors and then test the
machine. Often a loose or disconnected harness is the cause of the problem. Always do this before
you decide to replace the PCB.
 If a motor lock error occurs, check the mechanical load before you decide to replace the motor or
sensors.
 When a Pattern "A" or "B" SC occurs while in an SP mode, the machine cannot display the SC
number. If this occurs, check the SC number after leaving the SP mode.
 The machine reboots automatically when the machine issues a Pattern "D" SC code. This is done
for Level "D" SC codes only.