Ricoh Pro 8300S - Cancel Pre-Stack Operation in Staple Mode; First and Second Sheets Cannot be Aligned

4.Troubleshooting for Peripheral Units
794
By adjusting the SP value in the positive direction, the staple stacking fence is moved up and toward
the trailing edge fence.
By adjusting the value in the negative direction, the staple stacking fence is moved down and away
from the trailing edge fence.
First and Second Sheets Cannot be Aligned
When two pre-stack sheets are transported simultaneously to the trailing edge fence by the positioning
roller, only the second sheet reaches the trailing edge fence while the first sheet does not, and they are
stapled.
Cause:
This occurs because the friction resistance between the first and second sheets is smaller than that
between the staple tray and the first sheet.
During the first alignment of pre-stack paper in staple mode, the second pre-stack sheet reaches the
trailing edge fence earlier than the first sheet, and the first sheet is shifted to the transport direction.
Solution:
Cancel pre-stack operation in staple mode.
 SP6-116-1 to 15 (CrnrStplrMxPrstkShAdj:2K/3KFIN)
 Change default "0" to "-1".