Ricoh Pro 8300S - Toner Scatter 2 (Trailing Scatter)

2.Image Quality Problems
642
No
Increase the setting by another 5%.
3. If repeating Step 2 does not solve the problem, consult the product specialist.
Toner Scatter 2 (Trailing Scatter)
There is toner scattering on parts of a line that is 5 mm (0.2 inches) or less.
Cause:
Air between images is compressed and blows off parts of a line.
This may occur when:
 Printing is done at high temperature or humidity
 Using coated or other slippery paper
 Printing line images at less than 5 mm (0.2 inches) intervals
 To adjust the following settings, register beforehand the type of paper that you are using as a
custom paper.
Solution:
The solution depends on the area where the line splatter occurred. If the splatter occurred 15 mm (0.6
inches) or less from the leading edge, carry out the procedure (a). Otherwise, go to the procedure (b).
(a) Toner Scatter Within 15 mm (0.6 inches) of the Leading Edge
1. Ask the client if the image start position can be shifted more that 15 mm away from the leading
edge.
Yes
Go to the next step.
No
Use different paper.