4.Troubleshooting for Peripheral Units
819
pressing the release button of the end fence.
5. Close the tray.
6. Return the tab holder to the pocket on the right side of the tray when you are finished using it.
Adjusting Tray Side-to-Side Registration
Normally, you can use SP1002 to adjust the position of the images for paper feed from the LCITs. You
can also change the paper feed position first, manually, by adjusting the support plate of the front cover
of the tray, and then, second, adjusting the position of the image with SP1002.
1. First, determine whether the paper stack needs to be moved to the front or the rear.
2. Pull out the tray.
3. There are three adjustment points on the left side [A] and right side [B] of the tray cover.
[1] These screws need to be loosened to release the cover. They do not need to be removed.
[2] This is the top adjustment grid (left and right).
[3] This is the bottom adjustment grid (left and right)
To Next Page
Loading...
