Ricoh Pro 8300S - Perfect Binder: Main Grip Rotate Enable Position Sensor Lag Error; Perfect Binder: Signature Move HP Sensor Error; Sc752-40; Sc752-41

1.SC Codes
427
SC752-40
Error Name
Perfect Binder: Main Grip Rotate Enable Position Sensor Lag Error
Pattern
D
Error Condition
While passing the signature, the MG rotate enable sensor did not go OFF, even though the signature
move motor had operated for 1450 ms.
Major Cause
 Signature move motor defective
 MG rotate enable sensor defective
 Connector harness loose, damaged, or defective
Solution
 Reconnect the connector.
 Replace the signature move motor.
 Replace the MG rotate enable sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC752-41
Error Name
Perfect Binder: Signature Move HP Sensor Error
Pattern
D
Error Condition
The signature move HP sensor and signature move MG position sensor went on at the same time.
Major Cause
 Signature move HP sensor defective
 Signature MG position HP sensor defective
 Connector harness loose, damaged, or defective