Ricoh Pro 8300S - Perfect Binder: Press End Sensor Late Jam; Sc750-53

1.SC Codes
337
 Press end sensor defective
 Overload
 Motor/sensor disconnected
Solution
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC750-53
Error Name
Perfect Binder: Press End Sensor Late Jam
Pattern
D
Error Condition
 The press end sensor does not go ON within 8 sec. after press operation started
 Operation stopped when the press end sensor went ON, but sensor went OFF after operation
stopped.
Major Cause
 Edge press plate motor defective
 Press end sensor defective
 Overload
 Motor/sensor disconnected
 No data about book thickness received
Solution
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.