Ricoh Pro 8300S - Sc753-16; Sc753-17

1.SC Codes
461
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC753-16
Error Name
Perfect Binder: Press plate late error
Pattern
B
Error Condition
 Edge press plate sensor did not go ON within 15 sec. of edge press release.
 The edge press plate motor stopped when the edge press plate HP sensor switched ON, but after
it stopped the HP sensor went OFF.
Major Cause
 Edge press plate motor connection loose, broken, defective
 Motor overloaded
 Motor defective
 Edge press plate HP sensor connection loose, broken, defective
 Sensor defective
Solution
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the edge press plate HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC753-17
Error Name
Perfect Binder: Press end sensor lag jam
Pattern
B
Error Condition
After the press plate released the signature and moved the prescribed distance, the press end sensor
did not go OFF.