4.Troubleshooting for Peripheral Units
822
Correcting Skew
Skew Correction Method
If One Vacuum Feed LCIT is Installed
Skew can be corrected using the pin [A] and bracket [B] between the main machine and LCIT by
inserting a skew correction shim [C].
If Two Vacuum Feed LCITs are Installed
If more than one LCIT is in the line, skew correction can be done by inserting the correction shim
between the main machine and LCIT closest to the main machine.
Each skew correction shim is 1.0 mm thick. Inserting one shim is equivalent to about 0.25/100
mm of correction in paper skew.
Up to four shims can be inserted to correct skew.
Skew Correction Procedure
Follow the procedure below to check for paper skew after installation.
1. Go into the SP mode. Select SP2-109-003 and print Test Pattern #14.
This is the Trim Pattern.
2. At the top of the SP mode screen, touch “Copy Screen” to go into the copy mode (the copy screen
To Next Page
Loading...
