4.Troubleshooting for Peripheral Units
821
hole at each adjustment point.
7. The adjustment range is ±2 mm in 0.5 mm steps for each hole.
In the example below, [A] is a full 2 mm adjustment to move the paper stack to the front. [B] is a full
2 mm adjustment to move the paper stack to the rear.
8. Tighten the screws on the top.
9. Close the tray.
10. Make some test prints, and then go into the SP mode and do the image adjustment for the tray with
SP1002.
To Next Page
Loading...
