Ricoh Pro 8300S - Correction Level Setting Tray; Envelopes Are Loaded.; J050 (Paper Registration); The Skew Detection Level Is too High

3.Paper Delivery Problems
699
the value noted in Step 1 and go to the next step.
4. In Advanced Settings for the custom paper in use, set Skew Detection to Off. (1341-03)
5. Print the image. Is the problem resolved?
Yes
Finished.
No
Consult the product specialist.
Envelopes are loaded.
When printing on envelopes with slanted flaps, a skew may be wrongly detected when the envelopes
are fed with their flaps open.
In such a case, disable the skew detection function.
When using as a custom paper:
In Advanced Settings for the custom paper in use, set Skew Detection to Off. (1341-03)
When not using as a custom paper:
On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/Output, and set
Skew Detection to Off. (SP1-021-001 to 013: Skew Detect Tray <number>)
The skew detection level is too high.
The skew detection level may be too high. Lower the skew detection level. (SP1-022-001 to 013: Skew
Correction Level Setting Tray <number>
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/Output, and
increase the value in Skew Detection Level. (SP1-022-001 to 008: Skew Correction Level Setting
Tray <number>. Moving the setting in the plus (+) direction will lower the detection level.
2. Print the image. Is the problem resolved?
Yes
Finished.
No
Keep increasing the value until the problem is resolved.
If the problem persists even though the setting has reached its maximum value, go to the
next step.
3. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/Output, and
set Skew Detection to Off. (SP1-021-001 to 013: Skew Detect Tray <number>)
 Lowering the skew detection level or disabling the skew detection function will resolve
misfeed. However, this may result in paper skew.
 The machine may be incorrectly detecting skew. For details, see False Paper Skew Detection.
J050 (Paper Registration)
Cause:
Sheets cannot be positioned properly for position adjustment in the paper registration unit.
Solution:
Take the appropriate action according to the cause of the problem.