Ricoh Pro 8300S - Excessive Shift or Skew, Image Skew on Paper; No Feeding

4.Troubleshooting for Peripheral Units
815
No Feeding
This problem is caused by a variety of factors.
 If no feeding persists, try feeding again from the paper tray of the main machine, instead of the
vacuum feed LCIT
1. Remove the paper from the paper tray and fan the paper. Problem solved?
Yes
Finished.
No
Go to next step.
2. Attach the tab sheet holder. (Attaching the Tab Holder) Problem solved?
Yes
Finished.
No
Go to next step.
3. Clean the feed unit. Problem solved?
Yes
Finished.
No
Go to next step.
4. Create a new custom paper setting.
5. In Advanced Settings, set 36: [Paper Feed Mode (Adjust Fan Level)] to “Moderate Nonfdg Red.
(Higher)”. Problem solved?
Yes
Finished.
No
Go to next step.
6. In Advanced Settings, set 36: [Paper Feed Mode (Adjust Fan Level)] to “Max Nonfdng Reduc.
(Highest)”. Problem solved?
Yes
Finished.
No
Go to next step.
7. In Advanced Settings, change 40: [Switch Paper Load Upper Limit] from [Low] (18mm) to [High]
(12mm). Problem solved?
Yes
Finished.
No
Go to next step.
8. Manually adjust the paper load upper limit. Problem solved?
Yes
Finished.
No
Go to next step.
9. Clean the paper feed belt. (Cleaning the Paper Feed Belt)
Excessive Shift or Skew, Image Skew on Paper
1. Is paper type less than Thick 3?
Yes
Go to next step.
No
Problem cannot be corrected in the field.
2. Create a new custom paper setting.
3. In Advanced Settings, change 40: [Switch Paper Load Upper Limit] from [Low] (18mm) to [High]