Ricoh Pro 8300S - Finisher SR5110; Booklet Finisher SR5120; Trailing Edge of Stapled Sheets Close to Paper Exit; Troubleshooting for Peripheral Units

4.Troubleshooting for Peripheral Units
778
4. Troubleshooting for Peripheral Units
Finisher SR5110/ Booklet Finisher SR5120
Trailing Edge of Stapled Sheets Close to Paper Exit
If the stapled sheets are curled strongly or become limp after delivery, the trailing edge of the sheets
may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
Cause:
This is likely to occur if:
 There is a tight curl on a delivered set of stapled sheets.
 Limp paper such as thin or recycled paper is used.
[A]
Trailing Edges
[B]
Output Tray
[C]
Paper Exit
In the illustration the trailing edges of the stack [A] on the output tray [B] are too close to the paper
exit [C]
Solution:
1. Attach the Z-fold support tray for multi-folding unit.
2. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
3. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/ Output >
Adjust Paper Curl > Set to "Adjust Concave Curl". (SP 1-906-001 to 007: De-curler Setting Tray
<number> :Paper Path Selection)
4. Select "Strong" or "Weak" to control the amount of curl correction as required.