Ricoh Pro 8300S - SC Code Descriptions; Self-Diagnostic Mode; Service Call Conditions

1.SC Codes
28
1. SC Codes
SC Code Descriptions
Self-Diagnostic Mode
Service Call Conditions
 At job end or when the machine is switched off, both sides of the ITB unit are lowered and
separated from the drums.
 However, after a power failure or accidental disconnection of the power cord, or after a
machine issues an SC code after a malfunction, both or one side of the ITB may remain up
against the drums.
 To avoid damage to the ITB, both sides of the ITB must be checked and lowered before the
ITB unit can be pulled out of the unit.
The ‘SC Table’ section shows the SC codes for controller errors and other errors. The latter are put into
four types. The type is determined by their reset procedures. The table shows the classification of the
SC codes.
Pattern
Display
How to reset
SC call or SC alarm
in customer support
system
A
The SC is immediately displayed on
the operation panel when SC occurs.
The error involves the fusing unit.
The machine operation is disabled.
The user cannot reset the error.
Reset the SC (set SP5-
810-1) and then cycle the
main power off and on.
Occurrence & alarm
count
Immediate alarm
B
When a function is selected, the SC
is displayed on the operation panel.
The machine cannot be used (down-
time mitigation).
Turn the operation switch
off and on.
Occurrence & alarm
count
Power OFF and ON
Alarm count and
alarm only if
recurrence
C
No display on the operation panel.
The machine operates as usual.
Only the SC history is
updated.
Occurrence
Logging count &
alarm count