Ricoh Pro 8300S - Toner Scatter 16 MM (0.6 Inches) or more from the Leading Edge; Toner Scatter 3 (Blemished Line or Character)

2.Image Quality Problems
643
2. Adjust the image position. In Advanced Settings for the custom paper in use:
 Specify Adj Image Position of Side1 With Feed for Side 1 of the paper. Adjust in the “+”
direction.
 Specify Adj Image Position of Side2 With Feed for Side 2. Adjust in the “–“ direction.
3. Adjust the mask width at the leading edge. In Advanced Settings for the custom paper in use,
specify Adjust Erase Margin of Leading Edge.
4. Adjust the original's leading edge margin.
 Shift the image more than 15 mm (0.6 inches) away from the leading edge.
 For details about adjusting the shift image and adjusting the mask width at the leading edge,
see the TCRU manual "Adjustment Item Menu Guide".
 If you cannot increase the leading edge margin to more than 15 mm (0.6 inches), consult the
product specialist.
(b) Toner Scatter 16 mm (0.6 inches) or More From the Leading Edge
1. In Advanced Settings for the custom paper in use, select Image Transfer Current Setting.
2. Check the present value. Is it the upper limit?
Yes
Go to Step 5.
No
Go to the next step.
3. Increase the absolute value of the current by 5 uA in Image Transfer Current Setting.
4. Print the image. Is the problem resolved?
Yes
Finished.
No
Increase the value by 5 uA. If the problem persists even though you have increased the
value to the upper limit (150 uA), go to the next step.
5. Does the client mind if image density is lower?
Yes
Go to the next step.
No
Use different paper.
6. In Advanced Settings for the custom paper in use, select Adjust Toner Adhesion.
7. Check the present value. Is it the lower limit?
Yes
Consult the product specialist.
No
Decrease the value by 1 in Adjust Toner Adhesion.
8. Print the image. Is the problem resolved?
Yes
Finished.
No
Repeat Steps 5 to 7. If the problem persists even though you have decreased the value to
the lower limit, consult the product specialist.
Toner Scatter 3 (Blemished Line or Character)
There is toner scattering on parts of a line or characters. This may occur on a line or character that is 8
to 13 mm (0.3 to 0.5 inches) from the trailing edge, and 20 mm (0.8 inches) or less from the left edge
facing the paper feed direction.