Ricoh Pro 8300S - Afterimages

2.Image Quality Problems
680
No
Repeat Steps 3 to 5. If the problem persists even though you have decreased the value to
-5, consult the product specialist.
Afterimages
An afterimage of the image printed just before the intended image appears.
Cause:
This may occur when the ITB's image history changes drastically, such as when printing a solid-fill
image after continuously printing vertical lines. When printing vertical lines, there is a potential
difference between the image and non-image areas, causing the lines to appear on the next solid-fill
image.
This may occur when:
 Printing is done at high temperature or humidity
 Printing on thin coated paper (Paper Weight 3 or lower) or on OHP sheets
 Printing an image that is very different from the previous one
 To adjust the following settings, register beforehand the type of paper that you are using as a
custom paper.
Solution:
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Image Quality > Adjust
Image Density > Image Density Adjustment: Manual Execute.
2. Can the image density be adjusted manually?
Yes
Adjust the image density manually. (SP3-011-001 Manual ProCon :Ex Normal ProCon)
No
Go to Step 4.
3. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
4. Are the paper transfer current settings at their lowest values?
 SP2-641-100 to 178: PTR Current:Side1 Custom Paper 100 to 178
 SP2-642-100 to 178: PTR Current:Side2 Custom Paper 100 to 178