Ricoh Pro 8300S - Perfect Binder: Entrance Path Sensor Late Error; Perfect Binder: Signature Exit Sensor Lag Error; Sc751-36; Sc751-37

1.SC Codes
375
 Replace the sensor harness.
 Clear the signature jam.
SC751-36
Error Name
Perfect Binder: Signature Exit Sensor Lag error
Pattern
D
Error Condition
When the power was turned on, the cover path was closed and the signature exit sensor detects paper
but the LE detect sensor does not.
Major Cause
 Signature exit sensor connector loose, damaged, or defective
 Sensor defective
Solution
 Reconnect the connector.
 Replace the signature exit sensor.
 Replace the LE detect sensor.
 Replace the slave control board.
 Replace the sensor harness.
 Clear the signature jam.
SC751-37
Error Name
Perfect Binder: Entrance Path Sensor Late Error
Pattern
D
Error Condition
During automatic exit operation, the entrance path sensor does not detect paper within 6860 ms after
gluing and stack transport started.
Major Cause
 Entrance path sensor connector loose, damaged, or defective
 Sensor defective