Ricoh Pro 8300S - Perfect Binder: Left Trimming Buffer HP Sensor Lag Error; Sc750-41

1.SC Codes
329
Major Cause
 Grip motor defective
 Grip end sensor defective
 There is overload
 Sensor flag defective
 Connector damaged or defective
Solution
 Reconnect the connector.
 Replace the grip motor.
 Replace the grip end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC750-41
Error Name
Perfect Binder: Left Trimming Buffer HP Sensor Lag Error
Pattern
D
Error Condition
The left trimmings buffer HP sensor did not go OFF within 3 sec. after the trimmings buffer moved away
from the sensor.
Major Cause
 Trimmings buffer motor defective
 Left trimmings buffer HP sensor defective
 Overload
 Connector damaged or defective
 Buffer full of trimmings
Solution
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the left trimming buffer HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.