Ricoh Pro 8300S - Sc753-15

1.SC Codes
460
Major Cause
 Book buffer tray motor connector loose, broken, defective
 Motor overload
 Motor defective
 Book collection buffer tray HP sensor loose, broken, defective, Blocked by paper scraps
Solution
 Reconnect the connector.
 Replace the book buffer tray motor.
 Replace the book collection buffer tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC753-15
Error Name
Perfect Binder: Press HP sensor lag error
Pattern
B
Error Condition
During press plate operation during trimming, the edge press plate HP sensor did not OFF after it had
time to move the prescribed distance.
Major Cause
 Edge press plate motor connection loose, broken, defective
 Motor overloaded, defective
 Edge press plate HP sensor connection loose, broken, defective
 Sensor defective
Solution
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the edge press plate HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.