Ricoh Pro 8300S - Color Is too Dense; Entire Image Faint

2.Image Quality Problems
676
Interval
Solution
(12.4 inches)
 If the problem persists, consult the product specialist.
Entire Image Faint
The entire image is fainter than normal.
Cause:
This may occur when:
 Continuously printing an image that consumes little toner
 The machine has not been used for a long period of time
 The machine is in a very humid location and has not been used for a while
Solution:
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Image Quality > Adjust
Image Density > Image Density Adjustment: Manual Execute. (SP3-011-002: Manual ProCon :Ex
Density Adjustment)
2. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
3. Increase the value by 1 in Adjust Maximum Image Density. (SP3-620-001: ProCon Target M/A
Maximum M/A:K)
4. Select Adjust Image Density and execute Image Density Adjustment: Manual Execute. (SP3-011-
002: Manual ProCon :Ex Density Adjustment)
5. Print the image. Is the problem resolved?
Yes
Finished.
No
Repeat Steps 3 to 5. If the problem persists even though you have increased the value to
5, consult the product specialist.
Color Is Too Dense
The entire image is denser than normal.