Ricoh Pro 8300S - Convex Curl with Plain Paper?; Convex Curl Within Specification?; Print the Image. Problem Solved?

4.Troubleshooting for Peripheral Units
828
Yes
In the Adjustment Settings for Skilled Operators menu, set 0310: [Adjust Paper Curl] to
[Adjust Curl: Weak].
Go to next step.
No
Go to next step 7.
2. Print the image. Problem solved?
Yes
Finished.
No
Go to next step.
3. Set 0310: [Adjust Paper Curl] to [Adjust Curl: Strong].
4. Print the image. Problem solved?
Yes
Finished.
No
Go to next step.
5. Convex curl within specification?
Yes
The problem cannot be corrected in the field.
No
Go to next step.
6. Turn the stack upside down, and go to step 3 again. If the amount of curl exceeds specification, do
SP1984-101 to 131 to lower fusing temperature by 5°C to 10°C to reduce the amount of curl. You
can also use the Custom Paper Settings > 44: [Fusing Heat Roller Temperature Adj.] to adjust the
fusing temperature.
7. Convex curl with Plain Paper?
Yes
In the Adjustment Settings for Skilled Operators menu, set 0310: [Adjust Paper Curl] to
[Adjust Curl: Weak].
Go to next step.
No
The problem cannot be corrected in the field.
8. Print the image. Problem solved??
Yes
Finished.
No
Go to next step.
9. Set 0310: [Adjust Paper Curl] to [Adjust Curl: Strong].
10. Print the image. Problem solved??
Yes
Finished.
No
Go to next step.
11. Convex curl within specification?
Yes
The problem cannot be corrected in the field.
No
Go to next step.
12. Turn the stack upside down, and go to Step 9 again. If the amount of curl exceeds specification,
use SP1984-101 to 131 to lower fusing temperature by 5°C to 10°C to reduce the amount of curl.
You can also use the Custom Paper Settings > 44: [Fusing Heat Roller Temperature Adj.] to adjust
the fusing temperature.