Ricoh Pro 8300S - Perfect Binder: Press Limit Sensor Error; Perfect Binder: Slide HP Sensor Lag Error; Sc750-54; Sc750-55

1.SC Codes
338
SC750-54
Error Name
Perfect Binder: Press Limit Sensor Error
Pattern
D
Error Condition
Press limit sensor turns ON.
Major Cause
 Press limit sensor defective
 Press HP sensor defective
 Sensor disconnected
Solution
 Reconnect the connector.
 Replace the press limit sensor.
 Replace the press HP sensor.
 Replace the cutter control board.
 Replace the sensor harness.
SC750-55
Error Name
Perfect Binder: Slide HP Sensor Lag Error
Pattern
D
Error Condition
When the slide was raised, the slide HP sensor does not go OFF after it moved 180 mm.
Major Cause
 Slide motor defective
 Slide HP sensor defective
 Overload
 Motor/sensor disconnected
 Book jam