Ricoh Pro 8300S - Perfect Binder: Grip End Sensor Lag Error; Perfect Binder: Grip End Sensor Late Error; Sc750-39; Sc750-40

1.SC Codes
328
 Replace the motor harness.
 Replace the sensor harness.
SC750-39
Error Name
Perfect Binder: Grip End Sensor Lag Error
Pattern
D
Error Condition
 The grip end sensor did not go off after the grip unit was released and moved the prescribed
distance.
 The grip end sensor did not go off, even after the booklet has been released after moving 86 mm.
Major Cause
 Grip motor defective
 Grip end sensor defective
 There is overload
 Sensor flag defective
 Connector damaged or defective
Solution
 Reconnect the connector.
 Replace the grip motor.
 Replace the grip end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC750-40
Error Name
Perfect Binder: Grip End Sensor Late Error
Pattern
D
Error Condition
 The grip end sensor did not go on, even after the booklet has been moved 86 mm.
 The grip end sensor did not go on within 3.7 sec. after the book was gripped.