Ricoh Pro 8300S - Perfect Binder: Edge Press Plate Late Error; Perfect Binder: Press End Sensor Lag Jam; Sc750-51; Sc750-52

1.SC Codes
336
SC750-51
Error Name
Perfect Binder: Edge Press Plate Late Error
Pattern
D
Error Condition
 Edge press plate sensor does not go ON within 15 sec. of edge press release.
 The edge press plate motor stopped when the edge press plate HP sensor turned ON, but after it
stopped the HP sensor turned OFF.
Major Cause
 Edge press plate motor defective
 Press HP sensor defective
 Overload
 Motor or sensor disconnected
 Press end sensor defective
Solution
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC750-52
Error Name
Perfect Binder: Press End Sensor Lag Jam
Pattern
D
Error Condition
After the press plate released the signature and moved the prescribed distance, the press end sensor
does not go OFF.
Major Cause
 Edge press plate motor defective