Ricoh Pro 8300S - Perfect Binder: Master-To-Inserter Board Communication Error; Perfect Binder: Master-To-Inserter Initial Communication Error; Sc750-17; Sc750-18

1.SC Codes
320
Error Condition
When data was written to the EEPROM, the EEPROM signaled that it was busy for longer than 25 ms
and did not recover.
Major Cause
 EEPROM defective
 EEPROM not installed
Solution
 Install the master control board EEPROM.
 Replace the master control board EEPROM.
 Replace the master control board.
SC750-17
Error Name
Perfect Binder: Master-to-Inserter Initial Communication Error
Pattern
D
Error Condition
Inserter connection was detected, but initial communication was not completed within 5 sec after the
ConfigSet (parallel signal) went ON.
Major Cause
 Inserter board defective
 Connector loose, damaged, or defective.
Solution
 Reconnect the connector.
 Replace the master control board.
 Replace the inserter board.
 Replace the harness.
SC750-18
Error Name
Perfect Binder: Master-to-Inserter Board Communication Error
Pattern
D