Ricoh Pro 8300S - Jogger Fence 2 HP Error; Sc756-32

1.SC Codes
565
unit controller board). (Check all the connectors are properly connected.)
If the connector is not connected properly, reconnect the connector. Turn the power OFF/ON, and
then check if the SC recurs.
3. Check the harness.
Check the harness between jog fence motor 1/side fence 1 HP sensor and sub board (binder unit
controller board).
If the harness is damaged or exposed, replace it. Turn the power OFF/ON, and then check if the
SC recurs.
4. Replace the components.
 If the jog fence motor 1 does not operate, replace the motor.
 If the side fence 1 HP sensor does not react, replace the sensor.
 If the sub board (binder unit controller board) is defective, replace the board.
SC756-32
Error Name
Jogger Fence 2 HP Error
Pattern
B
Error Condition
 The rear jogger fence moved from home position, but home position is detected even after a
specified time had passed. (The first time is reported as a jam. An SC is issued the second time
this occurs.)
 The rear jogger fence has moved to the home position, but home position is not detected even
after a specified time had passed. (The first time is reported as a jam. An SC is issued the second
time this occurs.)
* The first time: Pre-punch jogger jam (J343)
Major Cause
 Power of downstream unit not turned on
 Motor defective (Jog fence motor 2)
 Connector disconnected
 Overload
 Home position sensor defective (Side fence 2 HP sensor)
Solution
1. Turn the power OFF and ON.
2. Check the connector.
Check the connection between the jog fence motor 2/side fence 2 HP sensor and sub board