Ricoh Pro 8300S - Page 232

1.SC Codes
224
Level
B
Error Condition
 Home position is not detected within the specified time when moving to the home position. (The
first four times are reported as jams. An SC is issued when it is repeated five times.)
 Home position remains detected after a specified time after leaving the home position. (The first
four times are reported as jams. An SC is issued when it is repeated five times.)
 The DCM drive software detected a motor drive error. (The first four times are reported as jams. An
SC is issued when it is repeated five times.)
Major Cause
 Power of downstream device is not turned on.
 Motor is defective
 Connector is not connected properly
 Harness is damaged
 There is overload.
 Encoder is defective.
 HP sensor is defective.
 Board is defective.
Corresponding Motor/Sensor/Unit
 720-35:
Vibrating plate vertical movement motor <DCSM07>
Vibrating plate vertical movement HP sensor (rear) <SN06>
 720-36:
Base fence movement motor <DCSM11>
Base fence front-back HP sensor (rear) <SN11>
 720-37:
Vibrating plate horizontal movement motor <DCSM08>
Vibrating plate horizontal movement HP sensor <SN07>
 720-39:
Leading edge stopper motor <DCSM13>
Leading edge stopper HP sensor <SN16>
 720-40:
Base fence lift motor <DCSM10>
Base fence up-down HP sensor <SN12>
 720-41:
Feed-out belt motor <DCSM12>
Stack feed-out belt HP sensor <SN17>