Rohde & Schwarz RTP Series - Page 1028

Jitter analysis and clock data recovery
R&S
®
RTP
1028User Manual 1337.9952.02 ─ 12
Use gate ← Gating
Enables the gating setup.
Remote command:
ADVJitter<m>:SIGNal:GATE:STATe on page 2267
Coupling mode ← Gating
Selects if the gate is coupled to the zoom or cursor.
To use the coupling mode, you have to enable a cursor or zoom first.
Remote command:
ADVJitter<m>:SIGNal:GATE:COUPling on page 2265
Cursor / Zoom ← Gating
Selects the cursor/ zoom the gate is coupled to, if "Coupling mode" is set to "Cursor
"/"Zoom".
Remote command:
ADVJitter<m>:SIGNal:GATE:CURSor on page 2265
ADVJitter<m>:SIGNal:GATE:ZDIagram on page 2267
Mode ← Gating
Selects if the gate area is defined in relative values (percent) or absolute.
Remote command:
ADVJitter<m>:SIGNal:GATE:RANGe:MODE on page 2266
Advanced jitter and noise (option R&S
RTP- K133/K134)