Rohde & Schwarz RTP Series - Page 2090

Remote control commands
R&S
®
RTP
2090User Manual 1337.9952.02 ─ 12
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STARt?.....................................................2091
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STOP?.....................................................2092
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:TYPE?..................................................... 2092
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:VAL?........................................................2092
BUS<m>:USBPd:RESult:FRAMe<n>:INFO?...................................................................2093
BUS<m>:USBPd:RESult:FRAMe<n>:STARt?................................................................. 2093
BUS<m>:USBPd:RESult:FRAMe<n>:STATe?................................................................. 2093
BUS<m>:USBPd:RESult:FRAMe<n>:STOP?..................................................................2094
BUS<m>:USBPd:RESult:FRAMe<n>:TYPE?..................................................................2094
BUS<m>:USBPd:RESult:FCOunt?
Returns the number of decoded frames in the selected serial bus.
Suffix:
<m>
.
1..4
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
Usage: Query only
BUS<m>:USBPd:RESult:FRAMe<n>:DATA?
Returns the data from the frame with the selected frame number (for the selected serial
bus). This is the hex value of the first four bytes of data fields, prefixed by the total
number of data fields (in square brackets), e.g. [5]FF008041.
Suffix:
<m>
.
1..4
<n> *
Return values:
<Data>
Usage: Query only
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:FVAL?
Returns the formatted value of the field with the selected field number within the frame
with the selected frame number (for the selected serial bus).
Suffix:
<m>
.
1..4
<n> *
Selects the frame number.
<o> *
Selects the field number.
Protocols