Rohde & Schwarz RTP Series - Page 2180

Remote control commands
R&S
®
RTP
2180User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:DDR:IOPerator <SearchName>,<Frame>, <Field>, <Operator>
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IOPerator
<SearchName>,<IndexOperator>
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IOPerator? <SearchName>
Sets the operator for the index for searching in the selected field of the selected frame.
Suffix:
<m>
.
*
<n> *
Parameters:
<IndexOperator> EQUal | INRange | RANGe
EQUal
This condition requires one endpoint value to be set using
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IMIN.
INRange | RANGe
This condition requires a range of endpoint values to be set
using SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IMIN and
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IMAX.
*RST: INRange
Parameters for setting and query:
<SearchName>
22.17.24.4 Search results
In all SEARch:RESult:DDR:FRAMe<m> commands, the suffix <m> selects the frame
number in the list of search results.
SEARch:RESult:DDR:FCOunt?..................................................................................... 2180
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:FVAL?..........................................................2181
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STARt?........................................................ 2181
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STATus?...................................................... 2181
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STOP?.........................................................2182
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:VAL?............................................................2182
SEARch:RESult:DDR:FRAMe<m>:NWRDs?.................................................................. 2183
SEARch:RESult:DDR:FRAMe<m>:STARt?.....................................................................2183
SEARch:RESult:DDR:FRAMe<m>:STATe?.....................................................................2183
SEARch:RESult:DDR:FRAMe<m>:STOP?..................................................................... 2184
SEARch:RESult:DDR:FRAMe<m>:TYPE?......................................................................2184
SEARch:RESult:DDR:FCOunt? <SearchName>
Returns the number of decoded frames in the search result.
Query parameters:
<SearchName>
Protocols