Rohde & Schwarz RTP Series - Page 903

Protocol analysis
R&S
®
RTP
903User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:PCIE:DLLP:FCTL:VCID on page 2150
DLLP PM conditions
Searches for a specified power management conditions.
PM Type ← DLLP PM conditions
Searches for a power management type.
Remote command:
SEARch:TRIGger:PCIE:DLLP:POWM on page 2153
DLLP Vendor conditions
Searches for a specified vendor conditions.
Vendor Pattern ← DLLP Vendor conditions
Searches for a vendor pattern.
Remote command:
SEARch:TRIGger:PCIE:DLLP:VPAT on page 2154
Ordered set condition
Searches for the enabled ordered sets.
"SKP OS"
Searches for an SKP ordered sets.
"Training Seq
1/2"
Searches for a training sequence ordered set.
"Fast Training
Seq"
Searches for a fast training sequence ordered set.
"Electrical Idle
OS"
Searches for an electrical idle ordered set that must be send by the
transmitter before it can enter the electrical idle.
"Electrical Idle
Exit OS"
Searches for an electrical idle exit ordered set.
"Start of data
sequence OS"
Available for PCIe "Generation" = " Gen 3 (8 Gbit/s)"
Searches for a start of data sequence order set.
"Compliance
Pattern"
Searches for a compliance pattern ordered set.
Remote command:
SEARch:TRIGger:PCIE:OSET:COMP on page 2157
SEARch:TRIGger:PCIE:OSET:EIDE on page 2157
SEARch:TRIGger:PCIE:OSET:EIDL on page 2157
SEARch:TRIGger:PCIE:OSET:FTS on page 2157
SEARch:TRIGger:PCIE:OSET:SKIP on page 2158
SEARch:TRIGger:PCIE:OSET:TSONe on page 2158
SEARch:TRIGger:PCIE:OSET:TSTWo on page 2158
SEARch:TRIGger:PCIE:OSET:SDS on page 2157
Error Condition
Searches for enabled error conditions.
PCIe (option R&S
RTP-K72/K73)