Configuring the Internal Baseband Source
R&S
®
SMBV100B
164User Manual 1178.4460.02 ─ 03
To generate a waveform file with the R&S WinIQSIM2
1. In the block diagram of R&S WinIQSIM2, select "Baseband > EUTRA/LTE/IoT".
2. Adjust the settings as required, for example:
a) select "Link Direction > Downlink"
b) select a predefined test model, "Test Setups/Models > E-TM1_1__10MHz"
3. Enable "EUTRA/LTE/IoT > State > On".
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
