Rohde & Schwarz SMBV100B - Page 241

Configuring the Internal Baseband Source
R&S
®
SMBV100B
239User Manual 1178.4460.02 ─ 03
c) Confirm with "Select".
2. To enable signal generation, select "3GPP FDD > General > ON".
3. To create a 3GPP ARB file, select "3GPP FDD > Generate Waveform".
Enter the name of the waveform file to be generated, for example 3gpp_1_16.
4. Confirm with "Save"
5. To set up a multi-carrier scenario with 4 carriers and a carrier spacing of 5 MHz,
select "Baseband > ARB > Multi Carrier".
Perform the following:
a) In the "General" dialog, select "Number of Carriers = 4" and "Carrier Spacing
= 5 MHz".
b) To load the generated waveform file to all 4 carriers, select "Carrier Table >
Carrier Table Assistant". Select "Carrier Start = 0" and "Carrier Stop = 3".
c) To load the generated waveform file to all 4 carriers, select "ARB Multi Carrier
Table > Input Waveform File". Navigate to the generated waveform file
3gpp_1_16 and select it.
d) Select "ARB Multi Carrier Table > Carrier State > On".
e) Select "ARB Multi Carrier Table > Apply Assistant Settings". Close the dialog.
The "ARB: Multi Carrier > Carrier Table" dialog confirms the configuration.
Generating Multi-Carrier Signals