Rohde & Schwarz SMBV100B - Page 362

Configuring the RF Signal
R&S
®
SMBV100B
360User Manual 1178.4460.02 ─ 03
"Ext Triggered"
Generates the pulse signal each time an external trigger event
occurs.
Example: Generation of single pulse signal ("Pulse Mode = Sin-
gle") using "Trigger Mode = Ext Triggered"
1 = External trigger signal input with "Trigger Input Polarity = Normal" (the positive
slope is active)
2 = Sync signal
3 = Pulse signal
Δt = Trigger delay between the trigger and the sync signal start; see data sheet
delay = "Pulse Delay = 100 ns"
PW = "Pulse Width = 100 ns"
Example: Generation of double pulse signal ("Pulse Mode = Dou-
ble") using "Trigger Mode = Ext Triggered"
1
= External trigger signal input with "Trigger Input Polarity = Normal" (the positive
slope is active)
2 = Sync signal
Analog Modulations