Rohde & Schwarz SMBV100B - Page 400

Configuring the RF Signal
R&S
®
SMBV100B
398User Manual 1178.4460.02 ─ 03
The "Overview" tab shows the list of detected sensors, and provides a separate tab
per sensor.
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in Chap-
ter 12.14, "SENSe, READ, INITiate and SLISt Subsystems", on page 649, includ-
ing the triggering of the measurement and the retrieval of measurement results.
Settings:
Sensor type and serial number .................................................................................. 399
Level (Peak) / Level (Average) ...................................................................................399
Sensor Mapping..........................................................................................................399
Sensor Settings...........................................................................................................399
└ State .............................................................................................................399
└ Zero ..............................................................................................................399
└ Display.......................................................................................................... 399
└ Permanent ......................................................................................... 400
└ Use Frequency Of.........................................................................................400
└ Frequency ....................................................................................................400
└ Level Offset State,Level Offset..................................................................... 400
└ Filter..............................................................................................................400
Improving Level Performance