Getting Started
R&S
®
SMBV100B
57User Manual 1178.4460.02 ─ 03
To verify the current connector configuration
The R&S SMBV100B is equipped with multipurpose bi-directional User connectors.
Because the signal direction, input or output, and the signal mapping are configurable,
we recommend that you check the current configuration before cabling or further
instrument's configurations.
1. To display an overview of the current mapping of the logical signals to the connec-
tors, perform one of the following:
● In the block diagram, select the Trigger/Marker/Clock status LEDs on the left
side of the "Baseband" block.
● Select "Baseband > Trigger Marker Clock".
The instrument uses its internal trigger and clock signals, and the default mapping
of the marker signals to the connectors.
2. To access the related connector settings, perform one of the following:
● Select "Global Connector Settings"
● Tap the connector name, for example select the connector "User 1"
Trying Out the Instrument
To Next Page
Loading...
