Rohde & Schwarz SMBV100B - Page 698

Remote Control Commands
R&S
®
SMBV100B
696User Manual 1178.4460.02 ─ 03
// Configure the frequency modulation settings and switch FM on
SOURce1:FM1:SOURce EXT1
SOURce1:FM1:DEViation 5000
// Query the input sensitivity at the external modulation input
:SOURCe1:FM1:SENSitivity?
// Response: 1000
// since the voltage value for full modulation is 1V,
// the resulting sensitivity is precisely 5000 Hz/V.
// Switch on FM and RF signal output
SOURce1:FM1:STATe 1
OUTPut1:STATe 1
The following commands are available:
[:SOURce<hw>]:FM<ch>:STATe......................................................................................696
[:SOURce<hw>]:FM<ch>[:DEViation]...............................................................................696
[:SOURce<hw>]:FM<ch>:SOURce.................................................................................. 697
[:SOURce<hw>]:FM:DEViation:MODE............................................................................. 697
[:SOURce<hw>]:FM:DEViation:SUM................................................................................698
[:SOURce<hw>]:FM:RATio..............................................................................................698
[:SOURce<hw>]:FM:MODE.............................................................................................698
[:SOURce<hw>]:FM:SENSitivity?.....................................................................................699
[:SOURce<hw>]:FM<ch>:STATe <State>
Activates frequency modulation.
Suffix:
FM<ch>
.
1..2
determines the modulation signal channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Creating a frequency modulated RF signal"
on page 694.
Manual operation: See "State" on page 352
[:SOURce<hw>]:FM<ch>[:DEViation] <Deviation>
Sets the modulation deviation of the frequency modulation in Hz.
Suffix:
FM<ch>
.
1|2
Modulation signal channel
SOURce Subsystem